NFC Automatic Barrier Gate Access Control Drop Arm For Entrance And
Drop arm function turnstile is mainly installed in entrance and
exit of shopping mall which has a large flow rate; it is most
popular in supermarket.
Drop arm function turnstile ---can be compatible with IC card , ID
card ,barcode card , fingerprint reading card recognition device
used for staff, provide civilized , orderly access methods;
effectively manage the access of staff . Can be widely used in the
station, wharf subway , factories, office building , hotel , clubs,
intelligent community , enterprises and institution that need
intelligent access management.
System Integration of the arm drop turnstile
1) Alternative Materials, Finishes and Custom Design
2) Access control System Integration
3) Ticket System Integration
4) Camera System Integration
5) Thermostat System Integration
6) Remote-Controlled Button
7) Usage Counters
8) Waterproof and Dustproof Design: IP41 for mechanical module,IP65 for electric module
Feature of the Arm drop turnstile:
1) NO mode & NC mode can be switched over by users easily &
2) Self-recovery function: the machine will recovery automatically
with invalid counting if passage
is not completed within pre-set time (5 seconds default, adjustable
3) Self-examine Function: it is convenient for users to maintain
4) Tailgating-detection function.
5) Intruding-alarm function.
6) Anti-pinch function: protection against finger entrapment and
7) Emergency-escape function: the obstacles will open automatically
by pressing the emergency button which can be remote-controlled
whether the power is on or not.
8) With interface of relay switch (the dry contact signal or +12V
electrical level signal or DC12V pulse signal of pulse width ≥
100ms, driving current ≥ 10mA), compatible with all kinds of acces
9) Each machine can be set by Physical Address (Optional).
10) Equipped with free control software for man-machine interface
& control command SDK.
Parameter of Arm drop turnstile
|Power supply||Single phase 220v,50Hz||Humidity||≤95%|
|Control Circuit||DC Brush Motor||Arm length||550mm|
|Passing Method||Bi- directional||Reader windows||2|
|Service Time||More than three million times||Weight||96KG|
|Shock Resistance||More tahn 80KG||Protection||IP51|
|Shock Absorber||Hydraulic Pressure||Environment||Inside,outside(awning)|
+12V level signal or pulse width>100ms 12V pulse, drive